DSE4130

The DSE4130 is an Auto Transfer Switch Generator Controller that has been designed to monitor the mains (utility) supply. When the mains (utility) power fails the module sends a start request to the generator control unit. When the generator is up and running the module transfers the load across. When the mains (utility) returns the module transfers the load back and removes the start command. The generator should then begin its shutdown procedure.   The Generator Control  module can be configured so that it follows the users pre-set start and stop sequences. The DSE4130 enclosure has a closed back.

Main Features	Automatic mains (utility) supply monitoring Load changeover control Manual start Protected solid state (PSS) outputs Front panel mounting Front panel programming LED indicators Configurable timers Configurable outputs Single/three phase mains sensing
Benefits	Transfer’s between mains and generator power On-site module configuration to match user requirements
Operation	The module is operated by the three push-buttons on the front:   Manual Off Load – This is used to manually start and run the engine off load. Should the mains (utility) supply fail, then the load is transferred to the generator automatically.     Manual On Load - This mode is used to manually start and run the engine on load.   Auto Mode – This puts the module into automatic mode, where it will await a mains failure. Upon detection it will send a start request to the generator control unit.
Alternative / Associated Products	DSE705 - Auto Transfer Switch Control Module